Position these lights to point at the backdrop and use manual settings to achieve the “blown out highlights” effect. Make sure the light reading is at least 3 stops higher than the light on your subject. Light bounced off the blown-out background will also create a back-lighting effect on your subject, the degree of back-lighting depends on the angle at which background light are pointed at the background.
To start constructing this DIY backdrop, measure how thick your elbow is compared to your curtain rod, and add electrical tape around the end of the rod until you have a tight fit. For most people, it will be easier to put a little bit of tape on at a time, testing the fit every so often until it’s snug, but measurements can give you a good base to start with. Don’t attach the rod to the elbow yet, however.
Drops & Props custom work is professional, high quality, and accurate. They were responsive to our needs and hustled to complete an order that had an impossibly tight turn around time. We ordered backdrops not only for our photo booth but to have a shared experience in every Etsy office across the globe. They made this happen for us and we are so grateful.
These lights worked perfectly for what I purchased them for - as part of the backdrop for my Christmas pictures. They are a great, long length and width and shine brightly, but they are not overpowering. I had no issues stringing them up at all. They have a steady on mode as well as several different blinking modes. My only complaint is that the plug did not fit into my standard outlet - it was very loose and kept sliding out, so I had to tape it in to use it. Also, there is no off switch, so these have to be unplugged when not in use. Like I said, though, they worked great for my intended purpose.